Yamaha NS-IW360C - Manual (Page 6)

6
CONNECTIONS
z Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the
receiver.
z Connect the (+) terminals on the receiver and speakers using the corresponding side of the cable. Connect
the (–) terminals on both components using the other side of the cable.
Notes:
z Make sure that the bare wires are not touching each other as this could damage the speaker and receiver.
z Connect one speaker to the left terminals of your receiver, and another speaker to the right terminals,
making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
z
How to connect
1 Loosen the knob.
2 Insert the bare wire. Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.
3 Tighten the knob and secure the cable. Test the
firmness of the connection by pulling lightly on the
cable at the terminal.
z
When using a banana plug
1 Tighten the terminal knob.
2 Insert the banana plug into the terminal.
NS-IW360C
+ –
Receiver
Loosen
Red (+)
Black (–)
1
2
(–)
(+)
Tighten 3
1
2
Banana plug