Zanussi ZKT631DX - Manual (Page 23)

23
If you are unable to remedy the problem by following the above sug-
gestions, please contact your local Service Force Centre.
1
Warning! Repairs to the appliance are only to be carried out by qualified
service engineers. Considerable danger to the user may result from improp-
er repairs.
3
If the appliance has been operated incorrectly, the visit from the service
technician or dealer may not take place free of charge, even during the war-
ranty period.
flashes Unsuitable cookware Use suitable cookware
No cookware on the cooking
zone Place cookware on the cook-
ing zone
The diameter of the bottom
of the cookware is too small
for the cooking zone Move onto a smaller cooking
zone
Use suitable cookware
is lit Overheating protection for
the cooking zone has been
triggered Switch off the cooking zone.
Switch the cooking zone on
again
Safety cut-out has been trig-
gered Switch off the cooking zone.
Switch the cooking zone on
again
and number are displayed Electronics fault Disconnect the appliance
from the electrical supply for
a few minutes (Take the fuse
out of the house’s wiring sys-
tem)
If after switching on again,
is displayed again, call the
customer service department
and minus are displayed Light rays that are too strong
on the control panel, for ex-
ample bright sunlight Briefly shade the control pan-
el, for example with the hand
Acoustic signal sounds, ap-
pliance switches itself off
Switch appliance on (again)
Problem Possible cause Remedy