Yamaha HTR-5630RDS - Manual (Page 72)

English
E-
11
1
Set the VOLUME control to minimum (0).
2
Turn on the power of all the other
components.
3
Press the POWER switch to the ON position.
* The power indicator on the front panel lights
up in green.
4
Play a source containing low-frequency
components and adjust the amplifier’s
volume control to the desired listening level.
5
Increase the volume gradually to adjust the
volume balance between the subwoofer and
the main speakers.
Normally, set the control to the level where you
can obtain a little more bass effect than when
this unit is not used.
● Once the volume balance between the subwoofer and
the main speakers is adjusted, you can adjust the
volume of your whole sound system by using the
amplifier’s volume control.
However, if you change the main speakers (NX-E130)
to others, you must make this adjustment again.
● For adjusting the VOLUME control, refer to
“Frequency characteristics” below.
20 50 100 200 500 Hz
40
50
60
70
80
90
100 dB
SW-P130
NX-E130
Ⅵ Frequency characteristics
Fig. 1 shows the frequency characteristics of the subwoofer. Fig. 2 shows the frequency characteristics when the
subwoofer is combined with NX-E130 and the subwoofer’s
volume level is set to the figured position.
Fig. 1
Fig. 2
20 50 100 200 500 Hz
40
50
60
70
80
90
100 dB
VOLUME
0 I0
NS-P100-106 ENG(UB)a 03.2.21, 9:08 AM 11