ZyXEL Communications Internet Security Gateway ZyWALL 2 Series - Manual (Page 580)

ZyWALL 2 User’s Guide
L-6 Firewall Commands
Chart L-1 Firewall Commands
FUNCTION COMMAND DESCRIPTION
config edit firewall set <set #>
rule <rule #> TCP destport-single
<port #> This command sets a rule to have the ZyWALL
check for TCP traffic with this destination address.
You may repeat this command to enter various,
non-consecutive port numbers.
config edit firewall set <set #>
rule <rule #> TCP destport-range
<start port #> <end port #> This command sets a rule to have the ZyWALL
check for TCP traffic with a destination port in this
range.
config edit firewall set <set #>
rule <rule #> UDP destport-single
<port #> This command sets a rule to have the ZyWALL
check for UDP traffic with this destination address.
You may repeat this command to enter various,
non-consecutive port numbers.
config edit firewall set <set #>
rule <rule #> UDP destport-range
<start port #> <end port #> This command sets a rule to have the ZyWALL
check for UDP traffic with a destination port in this
range.
D D e e l l e e t t e e
config delete firewall e-mail This command removes all of the settings for e-mail
alert.
config delete firewall attack This command resets all of the attack response
settings to their defaults.
config delete firewall set <set #> This command removes the specified set from the
firewall configuration.
config delete firewall set <set #>
rule
<rule #>
This command removes the specified rule in a
firewall configuration set.