Yamaha RX-V390 - Manual (Page 12)

12
7
Select the center channel output mode according to your
speaker configuration.
(Refer to “SPEAKER CONFIGURATION” on page 6.)
On the feature of each mode, refer to the “Note” shown
below.
8
9
Turn up the volume.
You will hear a test tone (like pink noise) from the left front
speaker, then the center speaker, then the right front
speaker, and then the rear speakers, for about two
seconds each. The display changes as shown below.
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
Note
In step 7, when you select the center channel output mode,
note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use a center speaker
that is smaller than the front speakers. In this
mode, the bass tone will be output from the front
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the front speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and right front speakers.
*
When the DOLBY 3 STEREO program is used, the
PHANTOM mode cannot be selected.
Flashes continuously. CENTER
MODE
TEST
TEST
NORMAL
WIDE
PHANTOM
Front (L) Center
Rear
(L and R)
Front (R)
DECK A/B VCR MON REC/PAUSE STOP
ENHANCED
— +
+
—
CENTER
MODE PRO LOGIC
MONO MOVIE ROCK
DELAY
TIME
EFFECT
ON/OFF VOLUME
SUR.
CNCT VIDEO
HALL
9
7
DECK A/B VCR MON REC/PAUSE STOP
3 STEREO
— +
+
—
CENTER
MODE PRO LOGIC
HALL ROCK
DELAY
TIME
EFFECT
ON/OFF VOLUME
SUR.
9
7
9 8
RX-V490 RX-V390
RX-V390 RX-V490
RX-V390 only (L and R)