Yamaha NS-555 - Manual (Page 2)

2
.
When placing the speakers, be sure to use the stands to
increase stability.
Note
The provided stands are in two types. Two stands are for the right
side and others are for the left side. Attach each stand to the proper
position on the bottom of the speaker by following the figure
below.
Use the 8 specified holes located on the base of the speaker.
Procedure:
1 First, put the screw through the washer, then through
the inner hole of the stand, and screw it into the outside
hole of the speaker. Do not tighten too much at this
point.
2 Put a screw through the outer hole on the stand, and
screw it into the other hole on the base of the speaker.
3 Tighten both of the screws firmly.
4 Attach a pad to the bottom of the end portion of the
stand.
5 Attach the other stands to the other corners of the base
of the speaker in the same way and confirm that all 4
stands have been firmly attached.
Note
Be carefull not to apply force to the side of the speaker, otherwise
the speaker may fall causing damage to the speaker or personal
injury.
ATTACHING THE STANDS
(L) (R)
Stand (R x 2, L x 2)
Pad x 4 Washer x 4
Screw
(25mm) x 8
Back
(L)
(R)
(R)
(L)
Front
View from the bottom of the speaker
Outer hole
Inner hole
05AAGHO 2CIG  6WGUFC[ /CTEJ     2/