Yamaha CDC-655 - Manual (Page 15)

15
To stop program play
Press the STOP button. The first programmed track number
will be displayed.
To resume play, press the PLAY button. Play will begin from
the beginning of the program.
To cancel a programmed sequence
There are several methods, as described below.
● Press the STOP button while the unit is stopped.
● Open the disc tray.
● Switch off the power.
● CDC-555 only
Press the CLEAR button while the unit is stopped.
To check programmed data
1. If during program play, press the STOP button.
2. Press the PROG button.
3. Each time the SKIP
button is pressed, the track
numbers and sequential order of the programmed tracks
can be checked one after another. The display of the track
number can be returned (sequentially in reverse order) by
pressing the SKIP
button.
To correct programmed data
1. Follow the procedure described in “To check programmed
data”.
2. Display the track number to be corrected by pressing the
SKIP button.
3. Press a numeric button to select a track to replace the one
displayed. The previously programmed track will be
cleared from the memory and the new one will be
programmed.
4. After the correction has been completed, press the PROG
button or PLAY button once again.
Notes
● You can program as many as 40 tracks at one time.
● If you choose to perform programming with the DISC 1 tray
empty, be sure to press a DISC SKIP button before starting
programming.
● You can program a whole disc by pressing “0”, instead of
one track. At that time, “AL” flashes in the display.
● If you will program tracks from more than one disc, before
you press the PROG button, check the total recorded time of
each disc on the disc tray by pressing the DISC SKIP button
in turn. Without this operation, the total time of the
programmed tracks will not be displayed during
programming.
● The total time of the programmed tracks will not be
displayed, if a track number higher than 20 is programmed.
● If, during programming, the TIME display mode-select button
is pressed, the program number display can be changed to
display the total time of the programmed tracks or no
information. To return to the previous display, press the
TIME display mode-select button once again.
● The SKIP ( and ) buttons can be used during
playing, but only within the range of the programmed tracks.
● The SEARCH ( and ) buttons can be used during
playing to search through all tracks, including
unprogrammed tracks.