Zenith R40W46 - Manual (Page 33)

Programming the Remote to operate other devices
33
The remote control for your projection TV is a multi-brand or
universal remote control. It can be programmed to operate most
remote-controllable devices of other manufacturers.
Note that the remote control may not control all models of other
brands.
1. Test your remote control.
To find out whether your remote control can operate the IR device
without programming, turn on the IR device such as a VCR and
press the corresponding mode button (VCR) on the remote
control, while pointing at the IR device. Test the POWER and CH
+/- buttons to see if IR device responds properly. If not, the remote
requires programming to operate the device.
2. Turn on the IR device to be programmed, then press the
corresponding mode button on the remote control.
3. Press the POWER and MUTE buttons simultaneously, the remote
control is ready to be programmed for the code.
4. There are two ways to find the right code for the IR device.
A. If you press the CH +/- buttons repeatedly, the codes will
change one at-a-time. Press the POWER button after each code
change. If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the remote.
Programming code numbers for the corresponding component
can be found on the following pages. Again, if the code is correct,
the device will turn off.
5. Press the EXIT button to store the code.
6. Test the remote control functions to see if the IR device responds
properly. If not, repeat from step 2.
1 2 3
4 5 6
7 8 9
0
tv vcr cable dvd sat
mode light power
tv/video sleep comp/dvi
flashbk cc arc
video audio
fcr mute
vol ch
swap pipch- pipch+ pip
still pip input position mts
menu exit
record stop pause
rew
play
ff
skip
right
enter
left
down
up
3/4
3
4
5
2
4