ZyXEL Communications NBG4115 - Manual (Page 56)

Chapter 5 AP Mode
User’s Guide
56
2
To set your NBG4115 to AP Mode, go to Maintenance > Sys OP Mode >
General and select Access Point.
Figure 25 Maintenance > Sys OP Mode > General
3
A pop-up appears providing information on this mode. Click OK in the pop-up
message window. (See
Section 22.2 on page 196 for more information on the
pop-up.) Click Apply. Your NBG4115 is now in AP Mode.
Note: You have to log in to the Web Configurator again when you change modes.
5.3 The Status Screen in AP Mode
Click on Status. The screen below shows the status screen in AP Mode.
Figure 26 Status: AP Mode