ZyXEL Communications P-335 Plus - Manual (Page 5)

ENGLISH
5
The PR Switch
The P-335 Plus can work as a router with print server or a print server only. To configure the P-335 Plus’s
operating mode, push the PR switch on the rear panel to either the P (Print server) or the R (Router) side.
Note: The connection wizard is available only when the P-335 Plus is in router mode.
The P-335 Plus in print server mode does not support DHCP server. To access the web
configurator, make sure your computer’s IP address is in the same subnet as the P-335 Plus.
When the P-335 Plus is in print server mode, all LAN and WAN ports act as a hub.
2 Accessing the Web Configurator
1 Make sure the PR switch on the rear panel is set to the R (Router) side.
2 Launch your web browser. Enter “192.168.1.1” as the web site address.
Note: If the login screen does not display, check your browser’s security settings (see
Troubleshooting for details) or make sure your computer is set to receive an IP address
dynamically (see
Set Up Your Computer’s IP Address ).
3 The Password window displays. Enter the
password (“1234” is the default) and click Login.
4 Change the password in the screen that follows
and click Apply.
5 Click Go to Wizard setup to set up your P-335 Plus
for the first time.