ZyXEL Communications Network Device P-2302 - Manual (Page 75)

Chapter 4 Status Screens
P-2302HWUDL-P1 Series User’s Guide
75
4.6 Packet Statistics Window
To access this screen, open the Status screen (see Section 4.1 on page 67 ), and click (Details
...) next to Packet Statistics.
Figure 35 Packet Statistics Window
Each field is described in the following table.
Poll Interval Enter how often you want the ZyXEL Device to update this screen, and click Set
Interval.
Set Interval Click this to make the ZyXEL Device update the screen based on the amount of
time you specified in Poll Interval.
Stop Click this to make the ZyXEL Device stop updating the screen.
Table 26 BW MGMT Monitor Window
LABEL DESCRIPTION
Table 27 Packet Statistics Window
LABEL DESCRIPTION
Port This field displays each port in the ZyXEL Device.
Status If the port is not connected to anything, this field displays Down.
If the interface uses Ethernet encapsulation, this field displays the port speed and
the Ethernet duplex setting. Duplex settings are:
Full - The ZyXEL Device is using full-duplex Ethernet.
Half - The ZyXEL Device is using half-duplex Ethernet.
You cannot change the Ethernet duplex setting in the ZyXEL Device.
If this interface uses PPPoE encapsulation, this field displays the port speed and
the status of the call.
Down - The connection is not available.
Dial - The ZyXEL Device is making the call.
Idle - The call is connected.
Drop - The ZyXEL Device is ending the call.
The LAN interface always uses Ethernet encapsulation. You can change the
encapsulation of the WAN interface in Network > WAN > Internet Connection.
Tx Pkts This field displays the number of packets the ZyXEL Device has transmitted from
the port.