ZyXEL Communications ZyXEL Dimension GS-3012 - Manual (Page 188)

GS-3012/GS-3012F User’s Guide
27-6 Cluster Management
Table 27-4 Configuring Cluster Management
LABEL DESCRIPTION
Cancel Click Cancel to begin configuring this part of the screen afresh.
Clustering
Candidate The following fields relate to the switches that are potential cluster members.
List A list of suitable candidates found by auto-discovery is shown here. The switches must be directly
connected. Directly connected switches that are set to be cluster managers will not be visible in the
Clustering Candidate list. Switches that are not in the same management VLAN group will not be
visible in the Clustering Candidate list.
Password Each cluster member’s password is its web configurator password. Select a member in the
Clustering Candidate list and then enter its web configurator password. If that switch administrator
changes the web configurator password afterwards, then it cannot be managed from the Cluster
Manager. Its Status is displayed as Error in the Cluster Management Status screen and a
warning icon (
) appears in the member summary list below.
If multiple devices have the same password then hold [SHIFT] and click those switches to select
them. Then enter their common web configurator password.
Apply Click Apply to save these changes to the switch.
Cancel Click Cancel to begin configuring this part of the screen afresh.
Refresh Click Refresh to perform auto-discovery again to list potential cluster members.
The next summary table shows the devices selected for clustering.
Index This is the index number of a cluster member switch.
MAC Address This is the cluster member switch’s hardware MAC address.
Name This is the cluster member switch’s System Name.
Model This is the cluster member switch’s model name.
Remove Select this checkbox and then click the Remove button to remove a cluster member switch from the
cluster.
Cancel Click Cancel to begin configuring this part of the screen afresh.