Yamaha RX-V690 - Manual (Page 32)

32
1
Set to the “LEARN” position.
2
Press a key on this unit where a new function will be
learned.
3
Press and hold the key (on the other remote control
transmitter) where the desired new function is.
* When the TRANSMIT/LEARN indicator stops lighting, the
learning is finished.
4
Repeat step 2 and 3 until all desired functions are
successfully learned.
5
Set to the “USER” position.
Try operating your components.
Notes
● When you operate the desired component with this remote
control transmitter, TRANSMIT/LEARN indicator will flash
steadily.
● The originally preset function of a key is still available in the
USER position if a new function has not been learned to the
key.
● Successful learning to a key results in the erasure of
previously learned functions and their replacement by the
newly learned ones.
● If there is no more room in the memory area for a function to
be learned, the TRANSMIT/LEARN indicator will flash on
and off. In this case, even if some keys are not occupied
with functions from other remote control transmitters, no
further learning is possible.
Memory back-up
All of the learned functions will be retained while you replace
the batteries. However, if no batteries are installed for a few
hours, the learned functions will be erased and will have to be
learned again.
To Learn a New Function
YPC
USER
LEARN
YPC
USER
LEARN
This unit
Other remote
control transmitter
About 5–10 cm
(2–4 in.)
Lights up.