Xerox V9.0 - Manual (Page 9)

9 of 16
3. If applicable, select a language for the administrative installation (not necessary if setup language
was specified in the command line).
4. During installation, specify a target network location for the administrative image to be
created.
5. Share this location (Software Distribution Point).
Software components and their installer locations for the Special Edition:
Software component Installer location on the CD-ROM Command
1 PaperPort 11 SE PP11SE\PaperPort SETUP /A
2 OmniPage SE 4 OPSE4\OmniPage SETUP /A
3 Image Retriever 7 SE IR70SE SETUP /A
4 PaperPort Image Printer PP11SE\PaperPort\PrinterDriver SETUP /A
Software components and their installer locations for the Professional Edition:
Software component Installer location on the CD-ROM Command
1 PaperPort Professional 11 PP11PRO\PaperPort SETUP /A
2 OmniPage Professional 15 OP15PRO\OmniPage SETUP /A
3 Image Retriever 7 Pro IR70PRO SETUP /A
4 PaperPort Image Printer PP11PRO\PaperPort\PrinterDriver SETUP /A
5 PDF Converter Professional 4 PDFCONV4PRO\<os>\PDFConverterPro SETUP /A
Note: PDF Converter Professional 4 and PaperPort Image Printer have 32- and 64-bit versions. They are located
at the folders <System32 or System64>, respectively. Use the ones appropriate for your target operating system.