Yamaha QY 300 - Manual (Page 6)

MIDI Data Format
– 6 –
Tone Generator
(1) TRANSMIT FLOW
NOTE ON/OFF 9nH
ACTIVE SENSING FEH
SW1 MIDI Transmit Channel
Output MIDI CH selects the MIDI Transmit Channel.
(2) RECEIVE FLOW
NOTE OFF 8nH
NOTE ON/OFF 9nH
BANK SEL MSB BnH, 00H
BANK SEL LSB BnH, 20H
MODULATION BnH, 01H
DATA ENTRY MSB BnH, 06H
DATA ENTRY LSB BnH, 26H
MASTER VOLUME BnH, 07H
PANPOT BnH, 0AH
EXPRESSION BnH, 0BH
HOLD 1 BnH, 40H
SOSTENUTO BnH, 42H
PORTAMENT CONTROL BnH, 54H
EFFECT SEND LEVEL 1 BnH, 5BH
DATA ENTRY INC BnH, 60H
DATA ENTRY DEC BnH, 61H
PITCH BEND SENSITIVITY
BnH, 64H, 00H, 65H, 00H, 06H, mmH
FINE TUNING
BnH, 64H, 01H, 65H, 00H, 06H, mmH, 26H, llH
COARSE TUNING
BnH, 64H, 02H, 65H, 00H, 06H, mmH
RPN RESET
BnH, 64H, 7FH, 65H, 7FH
ALL SOUND OFF BnH, 78H, 00H
RESET ALL CONTROLLERS
BnH, 79H, 00H
ALL NOTE OFF BnH, 7BH
OMNI MODE OFF BnH, 7CH
OMNI MODE ON BnH, 7DH
PROGRAM CHANGE CnH
PITCH BEND CHANGE EnH
F0H 7EH 7FH 09H 01H F7H
(GM MODE ON)
F0H 7FH 7FH 04H 01H llH mmH F7H
(MIDI MASTER VOLUME)
F0H 43H 1nH 27H 30H 00H 00H mmH llH ccH F7H
(MIDI MASTER TUNING)
ACTIVE SENSING FEH
(3) TRANSMIT/RECEIVE DATA
(3-1) CHANNEL VOICE MESSAGES
(3-1-1) NOTE OFF
STATUS 1000nnnn (8nH) n = 0 ~ 15 VOICE CHANNEL NUMBER
NOTE NUMBER 0kkkkkkk k = 0 (C-2) ~ 127 (G8)
VELOCITY 0vvvvvvv v: ignored
Receive-only
(3-1-2) NOTE ON/OFF
STATUS 1001nnnn (9nH) n = 0 ~ 15 VOICE CHANNEL NUMBER
NOTE NUMBER 0kkkkkkk k = 0 (C-2) ~ 127 (G8)
VELOCITY 0vvvvvvv (v 0) NOTE ON
00000000 (v=0) NOTE OFF
(3-1-3) CONTROL CHANGE
STATUS 1011nnnn (BnH) n = 0 ~ 15 VOICE CHANNEL NUMBER
CONTROL NUMBER 0ccccccc
CONTROL VALUE 0vvvvvvv
* CONTROL NUMBER’s are not transmitted.
* Received CONTROL NUMBER’s are as follows.
c = 0 BANK SEL MSB: v = 0:GM select, 127:RHYTHM select *2
c = 32 BANK SEL LSB: Always ignored
c = 1 MODULATION: v = 0 - 127 *2
c = 6 DATA ENTRY MSB: v = 0 - 127 *1
c = 38 DATA ENTRY LSB: v = 0 - 127 *1
c = 7 MASTER VOLUME: v = 0 - 127
c = 10 PANPOT: v = 0 - 127
c = 11 EXPRESSION: v = 0 - 127
c = 64 SUSTAIN SWITCH: v = 0 ~ 63 : OFF, 64 ~ 127 : ON *2
c = 66 SOSTENUTO: v = 0 ~ 63 : OFF, 64 ~ 127 : ON *2
c = 84 PORTAMENT CONTROL:v = 0 - 127 *2
c = 91 EFFECT SEND LEVEL 1: v = 0 - 127
c = 96 DATA ENTRY INC: v = 127 *1
c = 97 DATA ENTRY DEC: v = 127 *1
*1 Used only when setting parameter designated by RPN.
*2 Not effective for rhythm voice.
MODULATION controls vibrato depth.
For both melody and rhythm voices, PANPOT change is relative to the voice’s pre-
set value.
PORTAMENT CONTROL portamento time is fixed at 0.
BANK SELECT MSB v=0 selects GM melody voice, v=127 selects GM rhythm
voice. All other bank selections set the voice OFF.
BANK SELECT LSB is always ignored.
Channel 10 is fixed for rhythm voice; bank select is ineffective.
EFFECT SEND LEVEL 1 controls reverb depth.
(3-1-4) PROGRAM CHANGE
STATUS 1100nnnn (CnH) n = 0 ~ 15 VOICE CHANNEL NUMBER
PROGRAM NUMBER 0ppppppp p = 0 ~ 127
(Receive)
If receive channel is other than 10, and BANK SELECT MSB = 00, then
GM melody voice is selected.
If receive channel is channel 10 and BANK SELECT MSB = 127, then
GM rhythm voice is selected.
Dr1 (Standard Kit): p = 0
Dr2 (Room Kit): p = 8
Dr3 (Rock Kit): p = 16
Dr4 (Electonic Kit): p = 24
Dr5 (analog Kit): p = 25
Dr6 (Jazz Kit): p = 32
Dr7 (Brush Kit): p = 40
Dr8 (Classic Kit): p = 48
Values other than those listed above are ignored.
(3-1-5) PITCH BEND CHANGE
STATUS 1110nnnn (EnH) n = 0 ~ 15 VOICE CHANNEL NUMBER
LSB 0vvvvvvv PITCH BEND CHANGE LSB
MSB 0vvvvvvv PITCH BEND CHANGE MSB
Resolution: 14 bits
=/
SW1
MIDI
OUT
MIDI
IN