ZyXEL Communications Prestige 650 - Manual (Page 71)

Prestige 650 ADSL Router
Remote Node Configuration 4-5
FIELD DESCRIPTION EXAMPLE
Edit IP/Bridge Press [SPACE BAR] to select Yes and press [ENTER]
to display Menu 11.3 – Remote Node Network Layer
Options. No
Edit ATM Options Press [SPACE BAR] to select Yes and press [ENTER]
to display Menu 11.6 – Remote Node ATM Layer
Options. No
Telco Option
Allocated Budget (min)
This sets a ceiling for outgoing call time for this remote
node. The default for this field is 0 meaning no budget
control. 0
(default)
Period (hr) This field is the time period that the budget should be
reset. For example, if we are allowed to call this remote
node for a maximum of 10 minutes every hour, then the
Allocated Budget is (10 minutes) and the Period (hr)
is 1 (hour).
0
(default)
Schedule Sets This field is only applicable for PPPoE or PPPoA
encapsulation. You can apply up to four schedule sets
here. For more details please refer to the Call Schedule
Setup chapter.
Nailed up Connection This field is only applicable for PPPoE or PPPoA
encapsulation. This field specifies if you want to make
the connection to this remote node a nailed-up
connection. More details are given earlier in this
section.
No
Session Options
Edit Filter Sets
Use [SPACE BAR] to choose Yes and press [ENTER]
to open menu 11.5 to edit the filter sets. See the
Remote Node Filter section for more details. No
(default)
Idle Timeout (sec) Type the number of seconds (0-9999) that can elapse
when the Prestige is idle (there is no traffic going to the
remote node), before the Prestige automatically
disconnects the remote node. 0 means that the session
will not timeout. 0
(default)
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendors’ implementation includes specific authentication protocol in the user profile. It will disconnect if