XM Satellite Radio SA10175 - Manual (Page 36)

Appendix
36
For option 1 and rear mounting locations, route the cable into the trunk
as shown. Always cross the weather seal at the lowest part of the trunk
to reduce water leaks. From the trunk, route the cable into the passenger
compartment through available wire channels and then along the floor
under the door jamb trim or under the carpet to the front of the passenger
compartment. Do not leave the cable loose in the passenger compart-
ment where it is likely to be damaged.
For option 2 and front mounting locations, route the cable along the
door jamb and into the vehicle as shown. Route the cable across the
weather seal near the bottom of the door to reduce water leaks.
Step 2:
Be sure to locate your car cradle and receiver below the top of the dash in
your vehicle to keep your receiver within easy reach while driving.
Choosing a lower location in your installation should also make it easier to
manage the cables and achieve a more desirable appearance when the
installation is completed. A lower location for the receiver in the vehicle
will ensure that the installation does not cause interference with other FM
radios outside the vehicle.
See figure 2 and be sure to locate your car cradle within the shaded area.
11103RoadyXT_manual 6/19/06 11:02 AM Page 36