Zenoah EDG2300R - Manual (Page 26)

26
7. Operation
English
■ THROTTLE CABLE ADJUSTMENT
Check the throttle cable play and adjust to .04 or .08 in.
(1~2mm) at the carburetor side.
(1) Throttle cable (2) Adjusting screw
(3) Lock nut
■ STARTING ENGINE
1. Set ignition switch to "RUN" position. (OP2)
(1) Ignition switch
(A) RUN (B) STOP
2. When first starting up after putting fuel into the
machine, or when re-starting after running out of
fuel, push the priming pump until fuel runs out the
overflow pipe. (OP3)
(1) Choke lever (2) Overflow pipe
(3) Priming pump
(A) CLOSE (B) OPEN
3. Close the choke (push the choke lever front ward).
4. While firmly holding the auger as illustrated,
vigorously pull the starter rope.
5. When engine has ignited first, open the choke (move
the choke lever backward), pull the starter rope
again and the engine will start.
Keep the drill clear of everything around it as they
will start moving with the engine start.
6. Pull the throttle lever slightly, and it will be unlocked
automatically.
7. Allow the engine to warm up for a couple of minutes
before starting operation.
• When re-starting immediately after stopping engine,
keep the choke open.
• If the engine won't start even after repeated
attempts, it may be overfed with fuel. Remove and
dry the spark plug, and try to start again with the
choke open.
NOTE
WARNING
(1)
(2)
(3)
.04 or .08 in.
(1~2mm)
OP1
OP2
(1)
(A)
(B)
(2) (3)
OP3
OP4