Zephyr ZTO-M795 - Manual (Page 13)

FEATURES & CONTROLS
CONTROLS: FILTER CLEAN INDICATOR (Metal Filters)
Filter Clean Reminder (Standard Metal Filters fitted)
Whether your hood is installed as an Exhaust or Purifying unit, a set of metal filters are
fitted by the factory. These Metal Filters are intended to filter out residue from cooking.
It need not be replaced on a regular basis but are required to be kept clean. The Filter
Clean Reminder function in the microprocessor will automatically indicate by a flashing
when the metal filters are needed to be cleaned after every 30 hrs. of use.
Filters can be cleaned by hand or in a dishwasher with non-abrasive soap. Heavily soiled
filters should also be soaked in grease cutting detergent such as '409' or its equivalent,
prior to cleaning.
Filter Clean Reminder:
When flashes on display, the metal
filters installed are required to be cleaned.
This will occur after every 30 hours of use.
Re-setting Function:
Reset the Filter Clean Reminder timer when
filters are cleaned and re-installed. Press
and hold for approx. 5 seconds, the
display will appear; hold for approximately
5 seconds until on display disappears
. The Filter Clean Reminder function
is now re-set and a new 30 hours elapse
cycle is initiated.
hold 5 secs. display from <C> to < >
display <A> flashes
Clean Filters
To Reset
10