Tuning, Connecting the antennas, Connecting the indoor fm antenna – Yamaha HTR-5440 User Manual

Page 30: Connecting the am loop antenna

Advertising
background image

26

TUNING

Connecting the Antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
strength.

Connect each antenna correctly to the designated terminals.

Indoor FM
antenna
(included)

AM ANT

GND

FM ANT

75 UNBAL.

TUNER

5

4

Antenna stand

AM loop
antenna
(included)

Ground (GND terminal)
For maximum safety and
minimum interference, connect
the antenna GND terminal to a
good earth ground. A good earth
ground is a metal stake driven
into moist earth.

Connecting the indoor FM antenna

Connect the included indoor FM antenna to the FM ANT
75

Ω UNBAL. terminal.

Note

• Do not connect an outdoor FM antenna and the indoor FM

antenna at the same time.

Connecting the AM loop antenna

1

Press and hold the tab to unlock the terminal
hole.

2

Insert the AM loop antenna lead wires into the
AM ANT and GND terminals.

3

Release the tab to lock the lead wires.
Lightly pull the lead wires to confirm a good
connection.

4

Attach the loop antenna to the antenna stand.

5

Orient the AM loop antenna so that the best
reception is obtained.

y

• The AM loop antenna can be removed from the stand and

attached to a wall, etc.

Notes

• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA dealer
or service center about the outdoor antennas.

1

2

3

FREQUENCY STEP switch (China and General
models only)

Because the interstation frequency spacing
differs in different areas, set the
FREQUENCY STEP switch (locating at the
rear) according to the frequency spacing in
your area.
North, Central and South America: 100 kHz/
10 kHz
Other area: 50 kHz/9 kHz
Before setting this switch, disconnect the AC
power plug of this unit from the AC outlet.

100

K

H

Z

/10

K

H

Z

50

K

H

Z

/9

K

H

Z

FM/AM

FREQUENCY

STEP

(U.S.A. model)

0105HTR5450/5440_26-30_EN

3/28/1, 4:49 PM

26

Advertising