Zanussi ZCE 620 X - Manual (Page 23)

23
Something not working
SYMPTOM
■ The cooker does not operate.
■ The ceramic hob is not giving satisfactory results
■ The oven does not come on
■ The thermostat pilot light does not come on
■ The oven light does not come on
■ It takes too long to finish the dishes, or they are
cooked too fast.
■ Steam and condensation settle on the food and the
oven cavity.
■ The timer does not work
■ The oven fan is noisy
SOLUTION
◆ Check that the unit is plugged in and the electrical
supply is switched on
◆ Check that the RCCB has not tripped (if fitted)
◆ Check the mains fuse has not blown
◆ Check the correct control knob has been turned.
◆ Check the cooking pan is the correct size for the
cooking zone.
◆ Check the cooking pan has a flat base.
◆ Check the setting is correct for the type of
cooking.
◆ Check the oven is in manual operation and that
both a cooking function and temperature have been
selected.
◆ The socket switch or the switch from the mains
supply to the oven are ON.
◆ Select a temperature with the thermostat control
knob
◆ Select a function with the oven function control
knob.
◆ Select a function with the oven function control
knob
◆ Check the light bulb, and replace it if necessary
(see "Replacing the Oven Light")
◆ The temperature may need adjusting
◆ Refer to the contents of this booklet, especially to
the chapter “Using the Oven”.
◆ Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed. See page 10
◆ Check the instructions for the timer.
◆ Check that shelves and bakeware are not vibrating
in contact with the oven back panel.
If the appliance is not working correctly, please carry out the following checks before contacting your local
Zanussi Service Force Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.