ZyXEL Communications GS-4012 - Manual (Page 295)

Chapter 36 Access Control
GS-4012F/4024 User’s Guide
295
• A non-administrator (username is something other than admin) is someone who can view
but not configure Switch settings.
Click Access Control from the navigation panel and then click Logins from this screen.
Figure 177 Access Control: Logins
The following table describes the labels in this screen.
Table 120 Access Control: Logins
LABEL DESCRIPTION
Administrator
This is the default administrator account with the “admin” user name. You cannot change the default
administrator user name. Only the administrator has read/write access.
Old Password Type the existing system password (1234 is the default password when
shipped).
New Password Enter your new system password.
Retype to confirm Retype your new system password for confirmation
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give
users higher privileges via the CLI. For more information on assigning privileges see Chapter 45 on
page 325 .
User Name Set a user name (up to 32 ASCII characters long).
Password Enter your new system password.
Retype to confirm Retype your new system password for confirmation
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.