Yamaha 01X - Manual (Page 25)

01X Owner’s Manual
25
Before Using
Basics Section
Appendix
Getting Started
Reference
Basics Section
Overview of the 01X
This section gives you an overview of the 01X’s features. The following diagram shows the various component
sections or “blocks” of the 01X: mixer, effects and remote control. It also indicates the mLAN interface capabili-
ties, both audio and MIDI.
*1
MIDI
Computer
01X
StudioManager
Multi Part Editor
for MOTIF-RACK
Port
5
Port
4
Port
3
Port
1
Port
2
Acrobat Reader
(for PDF Manual)
Effect 1
Effect 2
AUDIO
DAW (Digital Audio Workstation)
AUDIO
MOTIF-RACK
USB MIDI
Driver
USB
*2
Software Effect
01X Channel Module
Pitch Fix
Vocal Rack
Final Master
Commercially
available
Software
Synthesizer
Plug-in Plug-in
Program
Change
MIDI
IEEE 1394 Connectors
(Fire Wire, i.Link)
MIDI B
IN/OUT
MIDI A
IN/OUT
MIC/LINE
INPUT
1 - 8 (A/D IN) DIGITAL
STEREO
OUT
DIGITAL
STEREO
IN
STEREO/
AUX OUT MONITOR
OUT
PHONES
mLAN Connectors 1/2
mLAN Driver (MIDI & Audio)
Effects
mLAN Audio/Audio conversion
*4
*3 *3
AUDIO
AUDIO
AUDIO AUDIO
AUDIO AUDIO
Mixer
mLAN IN
1 - 16
(1 - 8)
mLAN
STEREO IN
17,18 (9,10)
Monitor
Input
mLAN OUT
1 - 24
(1 - 16)
STEREO
Select
RECBUS AUX 1/2 AUX 3/4
STI 1
AUX 3
STI 2
AUX 4
STEREO
AUDIO
STEREO
Select
RECBUS AUX 1/2 AUX 3/4
AUDIO
mLAN
Audio IN/OUT
mLAN
MIDI IN/OUT
Remote Control Remote Control
mLAN
Audio IN/OUT
mLAN AUDIO
mLAN
MIDI IN/OUT
Remote Control of
Multi Part Editor
or
Program Change/
Scene Selection
(Port 5)
Remote Control
of DAW (Port 1)
Remote Control
mLAN
Auto Connector
mLAN
Driver Setup
mLAN
Audio IN/OUT
mLAN MIDI/MIDI conversion
Transfer with
Studio Manager
(Port 4)
STEREO
Select
RECBUS
AUX 1/2 AUX 3/4
Direct OUT 1 - 24
File exchange
Mix Balance
Signal flow between the 01X and the DAW on the computer
● When using a DAW other than SQ01 V2
*1 In Macintosh OS 9 or earlier, MIDI data is transferred between drivers
and applications by OMS (Open Music System).
*2 Windows only.
*3 Figures in parentheses indicate the number of available channels when
the wordclock is set to 88.2kHz or 96kHz.
*4 You can monitor the output directly (monitor cascade) through the con-
nected speaker system/headphones (according to the [MONITOR A/B]
setting), if the stereo master output of the DAW is set to the last two
available channels (the last two numbered channels specified with
mLAN Auto Connector; refer to the separate Installation Guide).