Zanussi ZOB 9900 X - Manual (Page 9)

Before calling your local Service Force be sure
you know how to operate your oven: it may help
you in explaining the malfunction to the
serviceman and check that there is not a power
cut (with the fuse still working). When you call
for service or order parts do not forget to give:
– model of your oven
– serial number
– colour (when in enamelled version)
– part name or/and description of the problem
– your full name, address, home phone number,
(or/and business phone number if appropriate).
The appliance must be installed by a qualified
techician accordingly with the instructions of this
booklet and with the installation requirements
and regulations in force in the user's Country.
The oven must be installed in a housing which
has been built to withstand a temperature of
120 ° C in accordance with EEC REGS.
The manufacturer declines any responsability
for faults arising from incorrect installation
or/and connection or/and inadequate
ventilation.
Electrical connection
The installer will be responsable for complying
with the safety regulations of the user's Country.
Servicing information
Instructions to the installer
L
N
- The electric power and sockets are suitable to
maximum power of the oven. (See data plate
on the appliance).
- WARNING: THIS APPLIANCE MUST BE
EARTHED.
The appliance’s electrical safety can only be
guaranteed when it has been correctly connected
to a properly earthed power supply, as laid down
in the regulations for electrical safety.
Important: the manufacturer cannot be held
responsible for any damage to persons or objects
due to the lack of an earth connection.
- Never use reducers, adaptors or branches for
connections.
CONNECTING OF FEEDING CABLE
- Connect the supply cable to the terminal strip
of the oven, keeping the earth wire 3 cm. longer
than the active conductors (live/neutral) .
- Connect cable’s wires as follows:
L =
(live) brown or red wire
N = (neutral) blue wire
= (earth) yellow - green wire.
N.B. Feeding’s cable temperature should never
reach 100°C.
Connection to normal socket
Connect feeding cable a normal plug suitable to
the load stated on data plate.
When the cooker has been built-in household
check that the plug is accesible.
Direct connection to electric supply
If an appliance is not equipped with supply cable
and plug, the power supply must be fitted with
a disconnect switch in which the distance
between contacts permits total disconnection in
accordance with overvoltage category III, as
required by installation regulations.
The yellow/green earth wire should not be
controlled by the switch..
9