Zanussi DWS 919 - Manual (Page 5)

5
Before using your dishwasher for the first time:
1. Ensure that the electrical and water connections
comply with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and
then fill with salt
5. Fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener
designed to remove minerals and salts from the water
supply, which would have a detrimental or adverse
effect on the operation of the appliance.
The higher the content of these salts, the harder your
water is.
Water hardness is measured in equivalent scales,
Clarke, French degrees and PPM (parts per Million).
The softener should be adjusted according to the
hardness of the water in your area. Your local Water
Authority can advise you on the hardness of the water
in your area.
The dishwasher is factory set at level 2.
If this level is not suitable for your area the softener
should be adjusted.
To adjust the water softener
With a screwdriver turn the selector on the upper front
corner of the machine until the level required
corresponds with the marker.
PDU06UKen
Before use
Level Use of
salt
French
degrees
(°TH)
PPM
(Parts per
Million)
Clarke
degrees
0
1
2
3
4
5
NO
YES
YES
YES
YES
YES
0 - 6
7 - 17
18 - 28
29 - 42
43 - 63
64 - 84
0 - 8
9 - 20
21 - 40
41 - 60
61 - 90
91 - 120
0 - 80
81 - 200
201 - 400
401 - 600
601 - 900
901 - 1200
Water hardness
If your water is level 0 it is already soft
and therefore there is no need to use salt.
In this case adjust the water softener to
level 1 without using salt.
2
AA05
1
3
5
4
2