ZyXEL Communications Prestige 100WH - Manual (Page 116)

Prestige 100WH Internet Access Router
10-14 Chapter 10 System Maintenance
10.7.1 Uploading Firmware
Menu 24.7.1 shows you the instructions for uploading RAS code (firmware). If you answer
yes to the prompt, the Prestige will reboot automatically. Press any key when you see the
message “Press Any key to enter Debug Mode within 3 seconds.” to enter debug mode.
Once in debug mode, type [atur] and wait for your Prestige to respond with “Starting
XMODEM upload” to begin uploading the new firmware (upload procedure varies depending
on the software used to access your Prestige). After successfully uploading the new firmware,
type [atgo
] to restart your Prestige.
Figure 10-11. Menu 24.7.1 - Example of Uploading RAS Using PCPLUS
Menu 24.7.1 -- System Maintenance - Upload RAS Code
To load the RAS code, type "atur" while in debug mode and wait for
"Starting XMODEM upload" before beginning to upload code.
Type "atgo" after code has successfully loaded to start RAS.
Proceeding with the upload will erase the current RAS code.
Do You Which To Proceed:(Y/N)