Troubleshooting guide for gasoline engines – Zenoah G26 AIR User Manual

Page 11

Advertising
background image

11

Troubleshooting Guide for Gasoline Engines

a) The engine does not start.

The crankshaft
does not rotate

Seizure, intrusion of a foreign substance

The fuel has not been fed to
the carburetor

The fuel has been fed to the
carburetor

The Stop switch has
been turned off

Wiring is disconnected

Disassemble and repair

Disassemble and clean

Clean

Loosened
spark plug

Abrasion or damage of
the cylinder, piston, or
piston ring

Tighten further

Replace

Readjust

Replace

Wet plug

Remove the spark

plug and dry it

The carburetor has
not been properly
adjusted

The fuel is not
suitable

Turn on

Repair

The spark plug does not spark

The spark plug does spark

Clogging inside the
carburetor

Clogging of the fuel
piping

No compression
(normally 7 kg/cm

2

99.5 psi or more)

The crankshaft
rotates

The spark plug is defective

The ignition module is defective

Replace
Replace

The air gap is too large

Adjust

The spark plug gap is too large

Adjust

Compression adequate

b) The engine stops by itself

It suddenly stops

The crankshaft does not rotate
or is abnormally heavy

The crankshaft
rotates

Out of fuel
Not out of fuel

The carburetor has not beeen properly adjusted

See a)

See a)

Put back

Repair

Use a standard plug

Turn on

Use clean fuel

Replace

The fuel is not fed to the carburetor
Water is mixed in the fuel

Replace

Replace

Refuel

Readjust

It slows down and stops

The plug cap has come off

Wiring disconnection

Spark plug bridge

The Stop switch has
been turned off

Air suction from a carburetor joint or oil seal

Abrasion of the piston ring

Repair
Replace

The fuel is not suitable

Clean

Clogging of the muffler or exhaust port due to carbon

The spark plug heat range is not proper

See c)

Repair

Overheating

Repair

The Stop switch is defective

Switch wiring is disconnected

c) Lower power output

d) The engine does not stop

Overheating

Generally speaking, there are very few things that will
keep today’s modern engines from starting. Use good
quality “fresh” fuel and make sure that good plugs are

installed. Should the engine fail to start after these items
are verified, refer to the charts on the following page.

Advertising
This manual is related to the following products: