Yard Machines 462 Thru 465 - Manual (Page 7)

7
9. Use wrenches to remove hex lock nut (D).
Remove two spacers (E), and hex bolt (F) from
top of the housing assembly. For easy
assembly, do not remove the second spacer
from the hex bolt. See Figure 5.
10. Place the discharge chute in position on the
discharge opening. Insert hex bolt (F) and
spacer (E) through hinge on discharge chute
and housing (spacer fits inside of hinge).
11. Place second spacer (E) over hex bolt (F) inside
the other half of the hinge. Secure with hex lock
nut (D). Tighten securely.
12. Secure both sides of discharge chute to flail
housing using wing knobs (C). Tighten wing
knobs.
ATTACHING THE CHIPPER CHUTE
(Model 463 or 465 chipper shredders)
Figure 6
1. Remove the three cupped washers and hex nuts
from the weld studs (A) beside the opening on
the left side of the housing. See Figure 6.
2. Remove the two hex bolts, lock nuts, and flat
washers from the two holes on the upper end of
the brace.
3. Place the chipper chute over the weld studs so
the slot on the chute is towards the bottom. Align
the three holes on the chute with the three weld
studs.
4. Replace the three cupped washers (cupped side
against the chipper chute) and hex nuts that you
removed in step 1. Do not tighten the nuts at this
time. Make sure to place the cupped side of the
washer against the chipper chute.
5. Your unit is shipped with one end of the brace
already secured to the lower frame. Loosen the
bolts securing the brace to the frame.
6. Align the holes on the chute with the holes on
the brace.
7. Attach brace to chipper chute with the hardware
removed earlier from the brace. Tighten
securely. See Figure 6.
8. Tighten the bolts securing the brace to the
frame.
9. Tighten the three nuts on the weld studs holding
the chipper chute to the flail housing.
ATTACHING THE BAG
All Models
1. To attach the bag, place the opening of the bag
over the chute deflector so it completely covers
the chute deflector. See Figure 7.
2. Depress the plunger on the drawstring, and pull
on the drawstring until the bag is tight around the
chute opening. Release plunger to lock it into
position. See Figure 7.
Figure 7
Brace
Weld Stud (A)
Weld Stud (A)
Weld Stud (A)
Chipper
Chute
Hex Bolt
Flat Washer
Hex Nut
Frame