X10 Wireless Technology VK48A - Manual (Page 6)

11 10
S ETTING UP THE C AMERA /V IDEO S ENDER
Referring to the diagram on the next page:
1. Attach the camera to a wall using the screws provided.
2. If you install the camera outdoors, make a small hole in your
exterior wall and pass the low voltage power jack through it.
3. Plug the power supply jack into the socket on the adapter cable
from the camera. Use the smaller of the two power supplies.
4. Plug the power supply into any 120V AC outlet.
5. Set the channel switch to any letter A, B, C, or D
6. Adjust the antenna if necessary to aim it in the direction of the TV
or monitor that you will view the camera on.
C
ONNECTING
U
P
2.4 GHz Video
Antenna
Plug power
supply in here.
Important: Unplug
power supply before
unplugging power jack.
Plug into
any AC
outlet
Set channel switch to
match setting on
Video Receiver.
Outdoors
Indoors
Attach camera to a
wall, indoors or
outdoors.