Zebra Technologies RW 220 - Manual (Page 10)

10
RW 220 Vehicle Cradle Installation Guide
Caution: It is strongly recommended that as a safety precaution the ad-
justable shoulder strap be removed prior to docking the Printer. This pre-
caution will ensure the strap will not interfere with proper operation of the
vehicle.
Printer Installation
The RW 220 Printer can now be installed in the Vehicle Cradle:
1. Place the bottom of the printer over the two pins in the
Cradle.
2. Rotate the Printer into the Cradle and press firmly until it
latches in place.
3. If you are using a Zebra Mobile Charger:
• Plug the Charger’s output cable into the charger jack on the
bottom of the printer.
Figure 3: Installing the Printer In The Vehicle Cradle
Rock the Printer into
the Cradle to latch
it in position.
Place the
Printer over the
Retaining Pins in
the Cradle.
Plug Charger out-
put cable into
Charger Jack
Plug data
I/O cable into
Communications
port