Zanussi DWS 949 - Manual (Page 13)

13
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Check that there is rinse aid
and salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4. Ensure that the spray arms can
rotate freely.
5. Measure out detergent
Add the required amount of detergent into the
dispenser according to the "Washing
programmes" chart.
Close the detergent dispenser lid.
6. Close the dishwasher door
7. Set the programme
Push the programme selector dial to make it
pop out.
Then turn the programme selector dial
clockwise until the letter of the programme you
wish to select corresponds with the programme
marker on the control panel.
Select the temperature according to the
instructions in the "Washing programmes" chart
(see "Required pushbuttons").
8. Start the programme
Depress the On/Off pushbutton.
The On/Off indicator light will come on and
the machine will start.
If you wish to interrupt the washing
programme at any time press this button
again.
9. At the end of the washing
programme
At the end of the programme the
dishwasher will automatically stop.
The On/Off indicator light remains on until
the On/Off pushbutton is depressed.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the
On/Off pushbutton and open the door.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working;if the
door is opened however, a safety device
ensures that the machine stops.
Important!
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
SEQ14en
Operating sequence