Yamaha mLAN Driver - Manual (Page 16)

16
Double-click the mLAN device icon, or select the mLAN device and select “MIDI Device
Info...” from the “Studio” menu. The following Device Info dialog box appears.
In this dialog box, you can use the pop-up menus in the “Send” and “Receive” columns to
specify which mLAN MIDI sequences (that are transmitted and received by the computer) are
assigned to which port.
The settings are stored as “mLAN OMS Driver Prefs” in the “mLAN Prefs” folder
inside the “Preferences” folder in the “System” folder.
The maximum number of ports is 8, but the maximum number of ports that can
actually be used equals the number of MIDI sequences specified in the mLAN
Control Panel. You cannot use sequences that have already been used by another
application.
A FireWire Card ID
This parameter displays the serial number of the FireWire (IEEE1394) interface card.
B Disable All
Click this button to disable all pop-up menus in the Channel Assignment column. Under
this condition, clicking [OK] will disable mLAN operation via the mLAN OMS driver.
C Revert
Click to reset the dialog box to its original status when first opened.
D OK
Click to enable the dialog box settings and close the dialog box.
E Cancel
Click to close the dialog box without changing the settings.
The changes made to the dialog box become valid immediately when you
click the [OK] button in the lower right corner.
You do not have to save the Studio Setup using the OMS Setup menu.
mLAN OMS Device Info dialog box
A
B
C E D