Zanussi ZBF 569 - Manual (Page 17)

1 7
Cleaning the oven door
The following instructions are relevant to the oven door
as it is supplied by the Manufacturer.
If the oven door has been reversed, please
note that the references to the right and left
side have to be switched.
Figure 1 . With the right hand, hold the aluminium slotted
bar (“A”) while pulling off the inner glass support “B”
with the left hand. Push the support towards the right
to release it and then lift it up.
Figure 2 . Remove the aluminium slotted bar “A” from
support “C”.
Figure 3 . Hold firmly the inner glass “D” with the left
hand and pull the support “C” off from its original
position.
Make sure that glass “D” is firmly held to prevent
it from falling down.
Figure 4 . Hold tighly the inner glass “D” with both hands
and remove it from its original position by sliding it
up.
After removing the inner glass, clean the oven door and
the glasses.
We recommend to clean the oven door using only a wet
sponge and dry it up after cleaning with a soft cloth.
Never use steel wool, acids or abrasive products as
they can damage the oven surface.
After cleaning, place the inner glass “D” back in its
original position.
To correctly mount the inner glass “D” (with stripes
along the sides) the surface marked with stripes
has to face the oven door in a way that, when
touching the surface on sight, the light roughness
of the silk-screen printing is not perceptible.
After placing the inner glass back, insert support “C” in
its position and, then:
A
B
A
C
D
C
D
Figure 1
Figure 2
Figure 3
Figure 4