Zephyr WHIRLWIND AK9800 - Manual (Page 15)

INSTALLATION
13
CONVERTIBLE OPTIONS
3-1/4 x 10“ Vertical Discharge
1. Remove pre-mounted 6“ transition adaptor on duct
opening. Leave attached gasket in its original place.
3. Mount the 3-1/4 x 10“ starting collar on top of
transition piece with remaining screws.
2. Place rectangular transition adaptor as shown over
gasket and by first installing 4 screws on half round
section.
Cyclone series: AK6000, 6036, 6042, 6048
Zephyr’s Cyclone series are equipped with the option of a 6“ vertical discharge, 3-1/4x10” vertical discharge, or 3-
1/4x10” rear discharge. Additional accessories are provided to convert to either of the above discharge methods.
Back Splash
Cyclone models also come with a standard back splash. If desired, install back splash to rear of range hood with
screws provided after all duct conversion steps below are completed.
Convertible Options
Vertical discharge
6“ round
Vertical discharge 3-1/4 x 10“
Horizontal rear discharge 3-1/4 x 10”
Convertible Accessories
6“ round duct cap
Round to rectangular transition adaptor
Rectangular to round transition adaptor (pre-
mounted)
Gasket (pre-mounted)
Rectangular rear cap (pre-mounted)
3-1/4 x 10“ starting collar