Yamaha YST-M20DSP - Manual (Page 5)

5
Rear Panel (left cabinet)
6
TO RIGHT SPEAKER: This should be connected to the TO LEFT
SPEAKER connection on the right cabinet using the supplied RCA plug cable.
Controls
Front Panel (right cabinet) (Refer to page 3)
7
POWER Switch and Indicator: Press to power on the YST-M15/M20DSPs;
the power indicate will light up. Press again to power off. Before powering on
and off, turn down the VOLUME control.
8
VOLUME control: Use this control to set the volume level. Turn it clockwise
to increase the volume, and counterclockwise to reduce it.
9
TONE control: This control allows frequency boost and cut of up to ±7 dB at
10 kHz. This tends to emphasize vocals, providing a warmer intimate sound.
Turn it clockwise to boost, and counterclockwise to cut.
0
DSP ON/OFF (YST-M20DSP only): Switch the DSP (Digital Surround
Processor) ON and OFF. The ON position will increase the sound expansion
(even in the headphones).
Note:
Digital noise may occur with some sources if you use DSP when the
volume level is low, or when there is no signal. If this occurs, increase
the volume or set DSP to OFF.
-
HEADPHONE: Use this jack to connect stereo headphones for monitoring.
No sound is output from the speakers or the OUTPUT (ADJ.VOL.) jack when
headphones are connected.
English
Specifications
Type Active Servo Technology Speaker System
Output power 10 W/ch. (1 kHz, 4 Ω at 10% T.H.D.)
Input sensitivity 230 mV (1 kHz, 4
Ω at 10 W)
Input Impedance 25 k Ω
Frequency response 70 to 20 kHz ± 3 dB
Speaker unit 8 cm (3") full-range cone, magnetic shielding
Output Impedance 900
Ω
Output level 0.6 V (at 230 mV Rated Input)
Power supply DC 14 V
U.S.A. and Canada models AC 120 V, 60 Hz
Europe and U.K. models AC 230 V, 50 Hz
Australia model AC 240 V, 50 Hz
Dimensions (W ×H×D) 94 (3 11 / 16 ") Ч 245 (9 5 / 8 ") Ч 155 (6 1 / 8 ") mm
Weight 1 kg (2 lbs 3 oz.)/Right channel unit
0.8 kg (1 lbs 12 oz.)/Left channel unit
Accessories AC adaptor × 1
3.5 mm stereo mini plug cable × 1
RCA plug cable × 1
Legs × 8
* Specifications subject to change without notice.
Cabinet Legs
The legs supplied with the YST-M15/M20DSPs should be
stuck onto the bottom of each speaker cabinet as shown. As
well as preventing the YST-M15/M20DSPs from slipping
around, these legs also isolate the cabinet from the mounting
surface.