Zanussi ZVM640F - Manual (Page 7)

You cannot activate or operate the
appliance. The appliance is not connected to
an electrical supply or it is con-
nected incorrectly. Check if the appliance is correctly
connected to the electrical supply
(refer to connection diagram).
Problem with the house electrical
system. Examine the fuse in the electrical
system of the house in the fuse
box. If the fuses blow again and
again, speak to qualified electri-
cian.
The residual heat indicator does
not come on. The cooking zone is not hot be-
cause it operated only for a short
time. If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on. Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
Installation
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
rating plate is on the bottom of the appliance
casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you as-
semble the appliance into correct built-in
units and work surfaces that align to the
standards.
Connection cable
• Use the correct mains cable of type H05BB-
F Tmax 90°C (or higher) for a single phase or
two phase connection.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C or
higher). Speak to your local Service Centre.
7
www.zanussi.com