Yazoo/Kees Z9 Commercial Collection System Z9A - Manual (Page 8)

8
1. Install the Hitch from the Custom Kit accord-
ing to the instruction sheet included in that
carton.
2. Slide the Z9 into the hitch.
3. Line up holes in the Hitch and Z9 and se-
cure with two (2) 3/8” wire lock pins.
4. Position the Hitch Brackets so that they are
aligned with the holes on the top plate of the
Hitch and the holes in the forward cross bar
of the Lower Frame.
5. Secure with four (4) 3/8” x 1-1/4” hex bolts,
four (4) 3/8” nylon lock nuts, and eight (8) 3/
8” flat washers.
Hitch
Hitch
Bracket
Wire Lock
Pin
Upper
Frame
Lower
Frame
ASSEMBLY
Mounting the Z9
NOTE: This portion of the assembly requires
lifting the Z9; two people are required.
Tools Required:
1. 9/16" wrench
2. Ratchet
3. 9/16" socket