Zanussi DE 6544 - Manual (Page 16)

16
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the ON-OFF push
button
The ON-OFF indicator light will come on.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms
can rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the recommended
quantity given in the Washing programmes
chart.
Close the detergent dispenser lid.
7. Close the dishwasher door
8. Setting and starting the
programme
Press the push button corresponding to the
required programme: the indicator light
corresponding to the programme illuminates
and the phase indicator lights for that
programme start flashing.
The start of the programme will occur after
about 6 seconds from the last pressure of a
push button, in this time it is possible to
change the programme simply pressing the
push button of another programme.
Once the programme has started the phase
indicator lights will turn off except for the
phase under way.
It is possible to interrupt the programme
by:
● opening the door
● pressing the ON-OFF (in this case all the
indicator lights turn off)
Close the door again o press the ON-OFF, the
programme will start from the point in which it
was interrupted.
9. To cancel a programme in
progress
A programme in progress can be cancelled at
any time.
Press for about 3 seconds the push button of
the running programme until all indicator lights
are off.
Only the ON-OFF indicator light will remain on
once the programme has been cancelled.
It is now possible to select a new washing
programme.
10. At the end of the washing
programme
The dishwasher will automatically stop and
the phase indicator light end of programme
will come on.
The indicator light of the programme just
ended will remain on.
Operating sequence