ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 71)

Chapter 6 Basic Setting
VES-1616F-3x Series User’s Guide
71
The following table describes the labels in this screen.
Table 12 IP Setup
LABEL DESCRIPTION
Domain Name
Server
Enter the IP address of the domain name server in dotted decimal notation, for
example 192.168.1.20.
Default
Management
Select which traffic flow (In-Band or Out-of-band) the switch is to use to send
packets with an unknown source or that originated from the switch itself (such as
SNMP traps).
Select Out-of-band to have the switch send the packets to the out-of-band
management port. This means that device(s) connected to the other port(s) do not
receive these packets.
Select In-Band to have the switch send the packets to all ports except the out-of-
band management port. This means that device(s) connected to out-of-band
management port do not receive these packets.
In-band Management IP Address
DHCP Client Select this option if you have a DHCP server that can assign the switch an IP
address and subnet mask, a default gateway IP address and a domain name server
IP address.
Static IP
Address
Select this option if you don't have a DHCP server or if you wish to assign static IP
address information to the switch. You need to fill in the following fields when you
select this option.
IP Address Enter the IP address of your switch in dotted decimal notation for example
192.168.1.1.
IP Subnet
Mask
Enter the IP subnet mask of your switch in dotted decimal notation for example
255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254
VID Enter the VLAN identification number associated with the switch IP address. This is
the VLAN ID of the CPU and is used for management only. The default is "1". All
ports, by default, are fixed members of this "management VLAN" in order to
manage the device from any port. If a port is not a member of this VLAN, then users
on that port cannot access the device. To access the switch make sure the port that
you are connected to is a member of Management VLAN.
Out-of-band Management IP Address
IP Address Enter the IP address of your switch in dotted decimal notation for example
192.168.0.1.
IP Subnet Mask Enter the IP subnet mask of your switch in dotted decimal notation for example
255.255.255.0.
Apply Click Apply to save the settings.
Cancel Click Cancel to reset the fields to your previous configuration.
In-band IP Addresses
You can create up to 128 IP addresses, which are used to access and manage the switch from the
ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address Enter the IP address for managing the switch by the members of the VLAN
specified in the VID field below.
IP Subnet Mask Enter the IP subnet mask in dotted decimal notation.
VID Type the VLAN group identification number.
Default Gateway Enter the IP address of the default outgoing gateway in dotted decimal notation.