Yamaha CD-R/RW Drive CRW6416SX - Manual (Page 16)

Rear Panel
The CRW6416SX drive’s rear panel features the following:
AC IN
SER. NO. st2
CDR ID
SCSI-1
SCSI-2
TERMINATOR
LINE OUT
R L
OFF ON
1
Serial number
This consists of 3 letters
and 7 digits. You may
need to refer to this
number when requesting
User Support services.
Power connector
Connect the included
power cable here. (P.18)
SCSI-1 & SCSI-2
connectors
Connect either of these to
your computer’s SCSI
adapter card using the
SCSI cable. The other
connector can be used as
a pass-through when
daisy-chaining more SCSI
devices to it. It can be left
vacant if your drive is the
last device on the SCSI
chain and is terminated.
(P.18)
LINE OUT connectors
To listen to audio CDs with
your drive, connect these
to the line-level input (LINE
IN) of your stereo
equipment using a
standard stereo phono
cable (sold separately).
CDR ID selector
switch
The drive’s SCSI ID number
is shown in the switch’s
window. Press the button
above the window to
decrement the SCSI ID
number, or the button
below the window to
increment it. (P.10)
TERMINATOR switch
This enables the drive’s
built-in SCSI termination.
Switch this to “ON” if your
drive is the last device on
the SCSI chain. Otherwise,
switch it to “OFF.” (P.11)
Front and Rear of Unit
9
CRWSX_e.qx 7/8/99 3:08 PM Page 16