ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 434)

Chapter 25 Logs Screens
ZyWALL 2WG User’s Guide
434
25.4.4 System Reports Specifications
The following table lists detailed specifications on the reports feature.
25.5 Log Descriptions
This section provides descriptions of example log messages.
Table 157 Report Specifications
LABEL DESCRIPTION
Number of web
sites/protocols
or ports/IP
addresses
listed:
20
Hit count limit: Up to 2 32 hits can be counted per web site. The count starts over at 0 if it passes
four billion.
Bytes count
limit:
Up to 2 64 bytes can be counted per protocol/port or LAN IP address. The count
starts over at 0 if it passes 2
64
bytes.
Table 158 System Maintenance Logs
LOG MESSAGE DESCRIPTION
Time calibration is
successful The router has adjusted its time based on information from
the time server.
Time calibration failed The router failed to get information from the time server.
WAN interface gets IP: %s A WAN interface got a new IP address from the DHCP,
PPPoE, PPTP or dial-up server.
DHCP client IP expired A DHCP client's IP address has expired.
DHCP server assigns %s The DHCP server assigned an IP address to a client.
Successful SMT login Someone has logged on to the router's SMT interface.
SMT login failed Someone has failed to log on to the router's SMT interface.
Successful WEB login Someone has logged on to the router's web configurator
interface.
WEB login failed Someone has failed to log on to the router's web configurator
interface.
Successful TELNET login Someone has logged on to the router via telnet.
TELNET login failed Someone has failed to log on to the router via telnet.
Successful FTP login Someone has logged on to the router via FTP.
FTP login failed Someone has failed to log on to the router via FTP.
NAT Session Table is Full! The maximum number of NAT session table entries has been
exceeded and the table is full.
Starting Connectivity
Monitor Starting Connectivity Monitor.
Time initialized by Daytime
Server The router got the time and date from the Daytime server.
Time initialized by Time
server The router got the time and date from the time server.