Zanussi DCE 5655 - Manual (Page 11)

- 11 -
General cleaning
Inspect the filters and spray arm nozzle before re-loading
the dishwasher and remove any food scraps. Wipe round
the rubber gasket at the bottom of the door to remove
grease which tends to collect there.
Cleaning the filters
There are two filters, a coarse one and a fine one which
should be cleaned after every wash. Lift out these filters
which are in the base of the dishwasher and wash under
running water.
The dishwasher must not be used without the
filters. Incorrect repositioning of the filters will
produce poor washing results.
Cleaning of the filters is vital to ensure correct
operation of the dishwasher.
Cleaning the spray arm nozzle
The holes in the spray arm nozzle must be kept free of
scraps for the efficiency of the washing action.
Inspect the spray arm regularly. When thorough cleaning
is necessary, remove the spray arm by unscrewing the
nut anti-clockwise, remove the washer and lift off the
spray arm.
Wash the spray arm with hot soapy water using a stiff
saucepan brush if necessary to remove scraps.
Re-assemble carefully, making sure the nut is secure.
Cleaning the cabinet
Wipe the outside of the cabinet and control panel regularly
with a soft damp cloth. When necessary, use washing up
liquid to remove stubborn marks, rinse with a damp cloth
and rub up with a soft duster.
Never use abrasive cleaners which could damage the
surface, ie: scouring pads or solvents (acetone, trichlori-
ethylene, etc).
If the dishwasher is not going to be used for some time,
take the following precautions:
1. Unplug the dishwasher and turn off the water
supply.
2. Fill up the rinse aid container.
3. Make sure the tub is clean by carrying out a
wash programme (without any crockery) using
Finish Dishwasher cleaner, then dry the inside
thoroughly.
4. Leave the door ajar.
Moving the dishwasher
If you have to move the dishwasher (you are moving
house, etc):
1. Unplug it.
2. Turn off the water tap.
3. Remove the water inlet and discharge hoses.
Avoid tilting the dishwasher during transportation.
Protecting the dishwasher against
freezing
If the dishwasher is placed in an environment
where the temperature sometimes fall below 0° C,
there is a risk that the small amount of water which
remains inside the parts of the dishwasher will
freeze and damage it. To prevent this you should:
1. Turn off the water supply to the dishwasher.
2. Remove the water inlet and discharge hoses.
3. Make sure that there is dishwasher salt in the
salt container for the water softener.
The appliance is only to be used and stored
indoors at normal room temperature. The manu-
facture is not responsible for any frost damage.
Maintenance and cleaning