Zanussi ZCM 8021 - Manual (Page 8)

8
Please note that this is a 24 hour clock, for example
2.00pm is shown as 1400.
In the following pages we explain how to set the
controls. Read through them a few times until you are
familiar with the procedure.
If the appliance is switched off on the wall, or there is
a loss of power, the clock will stop and you will not be
able to use the main oven. When you first switch the
electricity supply on, the timer display will flash.
TO SET THE TIME OF DAY
Turn the selector knob to ‘Manual’ then turn to ‘Clock’.
Set the correct time by turning and holding the setting
knob clockwise. Adjust the time by turning the setting
knob in either direction.
Turn the selector knob back to ‘Manual’.
TO USE THE TIMER
Turn the selector knob to ‘Timer’. Turn the setting
knob clockwise until the display shows the time you
want. The bell symbol ( ) will be showing and this
will stay lit up during the time. Our diagram shows the
timer set to 5 minutes.
If you change your mind and want to cancel the time
you have set, simply turn the setting knob
anticlockwise. Then turn the selector to ‘Manual’.
When you are using the timer you can make the clock
show the time of day by turning the selector knob to
‘Manual’. The bell symbol will stay on to remind you
that the timer is set. At the end of the timed period an
alarm will sound and the bell symbol will go out.
Switch off the alarm by turning the selector knob to
'Clock'. Then turn to 'Manual' and the time of day will
show in the display.
Note:
You can use the timer when an automatic sequence
has been set, as long as you remember the following
point.
1. Turn the selector knob to ‘Auto’ as soon as you
have entered the timed period into the display.
THE TIMER
Selector Setting knob
Cookpot symbol Bell symbol