Yamaha DSP-AX620 EN - Manual (Page 34)

32
SET MENU
1 SPEAKER SET (speaker mode
settings)
Use this feature to select suitable output modes for your
speaker configuration.
Notes
• When 96-kHz sampling digital signals are input to this unit,
level adjustments in items 1B and 1D are possible, but those in
items 1A,1C and 1E are not affected.
• When 6CH INPUT is selected as the input source, level
adjustments in items 1A through 1E are not affected.
■ 1A CENTER SP (center speaker
mode)
By adding a center speaker to your speaker configuration,
the unit can provide good dialog localization for many
listeners and superior synchronization of sound and
images. The OSD shows a large, small or no center
speaker depending on how you set this item.
Choices: LRG (large), SML (small), NONE
Initial setting: LRG
LRG
Select this if you have a large center speaker. The entire
range of the center channel signal is directed to the center
speaker.
SML
Select this if you have a small center speaker. The low-
frequency signals (90 Hz and below) of the center
channel are directed to the speakers selected with “1D
LFE/BASS OUT”.
4 Press j or i once to enter the setup mode of
the selected item.
The last setting you adjusted appears on the video
monitor or on the front panel display. Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the settings of the SET MENU you
adjusted will return to the factory settings. If so, adjust
the items again.
1A CENTER SP
LRG SML NONE
1A CENTER SP
LRG SML NONE
4A CMPNT-V INPUT
[B] • • • • • D-TV/CBL
[A] • • • • • DVD
y
• When making adjustments through the front panel, turn the
multi jog knob one step to either the left or the right to enter
setup mode for the selected item.
Depending on the item, press u/d to select a sub
item.
y
• When making adjustments through the front panel, press SET
MENU.
5 Press j / i repeatedly to change the setting
of the item.
4B OPTICAL OUT
(1) • • • • • MD/CD-R
4A CMPNT-V INPUT
[B] • • • • • D-TV/CBL
[A] • • • • • VCR 1
y
• When making adjustments through the front panel, turn the
multi jog knob to change the settings.
6 Press u/d repeatedly until the current DSP
program appears or simply press one of the
DSP program group button to exit from the
SET MENU.
y
• When operating through the front panel, press SET MENU
repeatedly until the DSP program name appears to exit from the
SET MENU.
or
0107AX620(GB)_31-39_EN 1/23/1, 9:27 AM 32