Yamaha HTR-5660 - Manual (Page 53)

49
English
AD
V
ANCED
OPERA
TION
REMOTE CONTROL OUT
REMOTE CONTROL OUT
CD INPUT
REMOTE CONTROL IN
ZONE 2 OUT
ZONE 2 (For U.S.A., Canada and Australia models)
You can make up a multi-room audio system with this unit.
Only analog signals are sent to the second room. For any source you want to listen to in the second room, you must
connect the analog output jack from the source to the corresponding analog input jack on this unit.
To use the multi-room functions of this unit, you need the following additional equipment:
• An amplifier and speakers for the second room
• An infrared signal receiver in the second room
• An infrared emitter in the main room
This emitter transmits the infrared signals from the remote control in the second room to the main room
(for example, to a CD player or DVD player).
y
• Since there are so many ways to connect and use this unit in a multi-room installation, we recommend that you consult with the
nearest authorized YAMAHA dealer or service center for the Zone 2 connections which will best meet your requirements.
• Some YAMAHA models are able to connect directly to the REMOTE CONTROL OUT jack of this unit. If you own these products,
you may not need to use an infrared emitter. Up to 6 YAMAHA components can be connected.
Note
• Using the unit in Zone 2 mode affects the signal that the unit outputs from the VCR 2/DVR OUT jacks. Do not use these jacks if you
wish to use Zone 2 functionality.
Example of a system configuration and connections
Main room
Infrared signal
receiver
Remote control
Second room
Amplifier
Infrared emitter
This unit
CD player
(or other component)
■ To enable Zone 2 mode
Set “OPTION 5 REC OUT” to ZONE 2 on the set menu.
• The ZONE 2 indicator on the front panel display appears when Zone 2 power is on, even if the main unit is in standby
mode.
■ Special considerations for playing DTS encoded materials
When playing DTS encoded materials, the analog output jacks of the source component may output excessive noise that
could damage your speakers. Due to this characteristic of DTS encoded discs, the following considerations and
adjustments need to be made.
For LDs or DVDs encoded with DTS
Only 2-channel analog audio signals will be sent to the second room. Set your player’s left and right outputs to the
analog soundtrack.
For CDs encoded with DTS
DO NOT USE the Zone 2 feature for CDs encoded with DTS to avoid unexpected noise.
0109HTR5660_45-50_EN-U.p65 03.1.14, 10:30 AM 49