Yamaha CDX-10 - Manual (Page 4)

• Before making any connections, switch OFF the power to
the unit and the amplifier or other component.
• Connections should be made to the correct input terminals of
the amplifier or other component.
• If the placement of this unit causes noise to other equipment,
such as a tuner, separate them from each other.
4
CONNECTIONS
Choose one of the ways listed below to connect this unit to your amplifier.
LINE OUT
1
CD
1
DIGITAL IN
OPTICAL
DIGITAL OUT
OPTICAL
To AC outlet
CDX-10
Amplifier or other component
Connection cord
(included)
Optical fiber cable
(not included)
To AC outlet
CDX-10
Amplifier with an optical terminal
When the LINE OUT (analog) terminals of this
unit are used (
1 )
• Be sure that the left (“L”) and right (“R”) LINE OUT terminals
are connected to the corresponding (left and right) terminals
of the amplifier or other component.
• Connect the “LINE OUT” terminals to the “CD” (or “AUX”)
terminals of the amplifier. If the amplifier does not have such
terminals, use the “TAPE PB” terminals. For additional
details concerning these connections, refer to the operation
instructions for the amplifier being used.
• The LINE OUT terminals of this unit are numbered 1 . When
connecting this unit with a YAMAHA amplifier or receiver
whose terminals on the rear panel are numbered as
1 , 2 ,
3 , etc., connect the LINE OUT terminals of this unit to the
input terminals numbered 1 on the rear of the amplifier or
receiver.
When the DIGITAL OUT (OPTICAL) terminal of
this unit is used (
2 )
• Before using this terminal, remove the terminal’s cover by
pulling it.
• Make the connection from this terminal to the optical input
terminal of an amplifier by using a commercially available
optical fiber cable.
* Use an optical fiber cable that conforms to EIAJ
standards. Other cables might not function correctly.
• Be sure to attach the terminal’s cover when this terminal is
not being used, in order to protect the terminal from dust.
• This terminal can also be connected to the optical input
terminal of a digital audio tape deck (DAT) etc. to record CD
onto tape directly.
1
2