Zenoah EBZ3000RH - Manual (Page 12)

GB-12
EBZ3000RH
FUEL FILTER
• A clogged fuel filter may cause poor acceleration of
the engine. Check periodically to see if the filter is
clogged with dirt. The filter can be taken out of the
fueling port using a small wire hook. Disconnect the
filter assembly from the fuel pipe and unhook the re-
tainer to disassemble it. Clean the components with
gasoline.
(1) Screen (2) Element
(3) Holder (4) Retainer
Daily Every Every Every
System / Compronent Procedure or 25 hours 50 hours 100 hours
Before use after after after
Air Filter Inspect / Clean ✔
Fuel Leaks Inspect / Replace ✔
Fuel Filter Inspect / Replace ✔ ✔
Fuel Line Inspect / Clean ✔
Spark Plug Inspect / Clean ✔
Muffler Inspect / Clean
✔
Muffler Spark Arrester Inspect / Clean
✔
Cooling Systrem Inspect / Clean
✔
Screws / Nuts / Bolts Tighten
✔
Cylinder Exhaust Port Inspect / Clean
✔
WARNING
Make sure that the engine has stopped and is
cool before performing any service to the
blower. Contact with rotating blower fan or hot
muffler may result in a personal injury.
AIR CLEANER
• Check the air cleaner every 25 hours of use or more
frequently if used under dusty conditions. A clogged
air filter may increase fuel consumption while cutting
down the engine power. Never operate the blower
without the air filter or with a deformed filter element
because unfiltered dusty air may quickly ruin the en-
gine.
CLEANING AIR FILTER:
1. Remove the air cleaner cover.
2. Use neutral detergent and warm water to clean the
filter element. After cleaning, air dry the element com-
pletely.
3. Reinstall the filter. Never forget to attach the screen. If
the screen is not attached, the cleaner will not seal
properly and the dusts come into the cylinder.
9. Maintenance
Maintenance, replacement, or repair of the emission control device and systems may be per-
formed by any non-road engine repair establishment or individual.
(1) Element
(2) Screen