Yamaha DPX-1200 - Manual (Page 53)

49
Connection
9
You can use the following two methods to connect to computer devices. Be sure to use cables with jacks that match the connectors and jacks
you wish to use. You cannot use a HDMI-DVI conversion cable to connect this unit and a computer device.
Connecting to computer devices
HDMI
G/Y B/P B /C B R/P R /C R
INPUT A
HD/SYNC VD
OUT IN
REMOTE TRIGGER OUT
S VIDEO VIDEO
INPUT B
RGB/YP B P R /YC B C R
RS-232C
D4 VIDEO
D-Sub monitor
cable
BNC monitor cable
Monitor output terminal
Computer devices
Input
INPUT A
INPUT B
Signal type
RGB (Analog)
RGB (Analog)
Connector type
BNC jack x 5
D-sub 15 pin
Use the supplied trigger-out DC plug to control external
components.
Be sure to solder the wires from an external component to the
plug terminals with the correct polarities, as illustrated at left.
Warning
• Soldering the wires to terminals with incorrect polarity may
cause bodily injury or may damage this unit and the
external component connected to this unit with this cable.
Information for installers
(for US model only)
+
polarity (inside)
-
polarity (outside)
(GND)
+
polarity
-
polarity
14_DPX-1100_E.p65 11/26/04, 1:57 PM 49