Zanussi ZCE 8020AX/CH - Manual (Page 8)

RATING PLATE
Record the model, product and serial numbers on the
back cover of this instruction book, from the rating
plate. This is situated on the lower front frame of the
appliance and can be seen upon opening the oven
door.
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance is
given on the rating plate.
Do not remove the rating plate from the cooker as
this may invalidate the guarantee.
INSTALLATION
If your cooker has been damaged in transit, contact
your supplier immediately. DO NOT attempt to install
it.
Your cooker left the factory fully packaged to protect
it from damage. If it is delivered without packaging
and damage has occurred, the manufacturer cannot
accept responsibility. Contact your supplier for advice.
Once the packaging has been removed the cooker
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the cooker as damage
may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation. The cable must have
conductors of sufficiently high cross-sectional area to
prevent overheating and deterioration.
The cable should be routed away from potentially hot
areas marked by X in the diagram below.
To move the cooker, open the main oven door and lift the
cooker by holding inside the top of the compartment.
This is a type X appliance which means it is free-standing
and can be fitted with cabinets on one or both sides. It
may also be fitted in a corner setting.
Side walls which are above hob level should be protected
by heat resistant non-combustible material and MUST
NOT be nearer than 40mm to the hob side.
A nominal air gap of 2mm at either side of the cooker is
required to enable the cooker to be moved into position. It
is recommended that proprietary trims are fitted to protect
the worktops of either side of the appliance. These are
available from most DIY stores.
Always ensure an air gap is maintained at hotplate level.
Tiles or other forms of deep wall covering should not
obscure this gap.
WARNING: THIS APPLIANCE MUST BE EARTHED
INTRODUCTION
Six square millimetres (6.00mm²) is the recommended
cross-section area.
Air gap
8