Yamaha YST-M101 - Manual (Page 5)

English
E-
1
Please read the following operating precautions before use.
YAMAHA will not be held responsible for any damage
and/or injury caused by not following the cautions below.
●
When you disconnect the AC adaptor from the AC
receptacle, hold the adaptor itself and not the cord.
●
If you plan not to use YST-M101 for a while, disconnect
the AC adaptor from the AC receptacle.
●
Always disconnect the AC adaptor from the AC
receptacle before making any connections.
●
YST-M101 does not contain any user serviceable parts.
Refer all servicing to your Yamaha dealer.
●
Never open the cabinet. If a foreign object drops into
the set, contact your dealer and stop using YST-M101.
Otherwise, you may cause a fire.
●
The voltage to be used must be the same as that
specified on the rear panel. Using YST-M101 with a
higher voltage than specified is dangerous and may
cause a fire and/or electric shock.
●
Do not expose YST-M101 to extreme temperatures,
direct sunlight, excessive dust, humidity, or vibration.
●
Position YST-M101 on a level, stable surface. Do not
drop, apply excessive force to their controls, or put heavy
items on top of them.
●
Do not place small metallic objects on YST-M101.
Otherwise, the object may fall, possibly causing an
injury.
●
Do not place the following objects on YST-M101:
Glass, china, etc.
If glass etc. falls by vibrations and breaks, it may cause
personal injury.
A burning candle etc.
If the candle falls by vibrations, it may cause fire and
personal injury.
A vessel with water in it
If the vessel falls by vibrations and water spills, it may
cause damage to YST-M101, and/or you may get an
electric shock.
●
Do not place YST-M101 where foreign objects such as
water drips might fall. It might cause a fire, damage to
YST-M101, and/or personal injury.
●
To protect YST-M101, avoid microphone feedback,
continuous and excessive output from electronic musical
instruments, and excessive signal distortion.
●
If YST-M101 is located close to fluorescent or neon
lights, a slight hum may be heard. In this case, relocate
YST-M101 away from the light.
●
Although YST-M101 is magnetically shielded, keep
floppy disks and tapes away from it.
●
Avoid sources of hum (transformers, motors). To prevent
fire or electrical shock, do not expose to rain or water.
●
When using a humidifier, be sure to avoid condensation
inside YST-M101 by allowing enough spaces around
YST-M101 or avoiding excess humidification.
Condensation might cause a fire, damage to YST-M101,
and/or electric shock.
●
Do not use force on switches, knobs, or cables. When
you move YST-M101, first turn off the power, then
disconnect the AC adaptor from the AC receptacle and
the cables from the connected devices.
●
Always set the POWER/VOLUME control fully to the left
(in the standby mode) before starting to play the audio
source: turn the control gradually after the play has
started.
●
Be sure to use the AC adaptor supplied with YST-
M101. Otherwise, you might cause a fire or damage
to YST-M101.
Standby mode
When YST-M101 is turned off by turning the POWER/
VOLUME control, YST-M101 consumes a small amount
of power. This state is called the standby mode. The
power supply is completely cut off from the AC line only
when the AC adaptor is disconnected.
YST-M101 features a magnetically shielded design, but
there is still a chance that placing it too close to a TV or
a computer monitor might impair picture color. Should
this happen, move YST-M101 away from the TV or the
computer monitor.
Thank you for selecting Yamaha’s YST-M101 Powered Multimedia Speakers. Yamaha Active Servo Technology offers
exceptionally high performance.
CAUTIONS
(See figure
1
on page IV .)
Make connections between the speakers and other
equipment as shown in the figure.
Caution: Plug in the right speaker and other
equipment after all connections are
completed.
CONNECTIONS